Batribike Diamond Pro Bedienungsanleitung Seite 4

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 8
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 3
4
STEP 1 - Unpacking
Please allow adequate space for building the bicycle. You can use the flattened
box as a working area.
TAKE CARE—Removal of the bicycle from the box may require the as-
sistance of another person. For the Granite and Diamond models the
stand should be extended and the bicycle placed on the floor for stability
ready for building.
The bicycle is protected by bubble-wrap and may be tied or tie-wrapped. Please
remove all packing material carefully and check the box for loose parts.
The front wheel on the Granite and Diamond models is attached to the side of
the main frame. Please take care when removing the packaging as the crank is
fitted through the spokes. Turn the crank slightly to allow easier removal. Take
care with the handlebars as they will be attached to the main frame by the ca-
bles only at this stage.
The battery is supplied locked into the frame and the keys are attached either to
the battery handle or to one of the cables on the front of the handlebars.
The charger and pedals are either packed separately in the box (Onyx) or taped
to the front forks. (Granite & Diamond)
Please dispose of the packing materials thoughtfully. The box can be recycled.
STEP 2 - Building
ONYX - Folding Model
The handlebars will need to be fitted to the handlebar tube. A locating groove is
designed into the tube to allow only one way of inserting the tube. Please ensure
that the cables are the correct side of the tube otherwise the cables will be
stretched and it will not be possible to fit the handlebars into the tube.
Lift up the tube and tighten the handlebar locking clamp into position.
Lift the rear of the cycle via the handle and rotate the front of the bicycle so that
the centre clamp is ready to fasten.
The centre clamp is fastened by lifting the lever to allow the bottom locating pin
to clip into the hole in the clamp. The quick release clamp is then swung into the
groove and tightened by moving the lever towards the frame. If it does not
Seitenansicht 3
1 2 3 4 5 6 7 8

Kommentare zu diesen Handbüchern

Keine Kommentare