5
tighten fully or is still loose after locking then the clamping pressure can be ad-
justed by the knurled nut. The clamp should be tight as it fits against the frame.
Fit the seat and adjust for height with the locking clamp. Adjust for clamping
pressure as necessary in the same manner as the main frame clamp.
Fit the pedals. Remember that the right hand pedal has a standard thread but
the left hand pedal has a reverse thread and must be tightened in the opposite
direction. A 15 mm spanner will be required.
Fit the wheel nut protectors, (grey cones supplied in the charger box) over the
wheel nuts.
Inflate the tyres to the correct pressure. (This is as stated on the wall of the tyre.
(Typically 40 to 60 psi)
Check that all of the levers etc on the handlebars are tightened and do not
swivel on the handlebars. Adjust as necessary using a Philips screwdriver or
small Hex key as appropriate. Take care not to over tighten.
Fit batteries, (not supplied), into the rear light if required. (2 AA cells) You will
need a small Philips screwdriver to remove the red lens.
GRANITE & DIAMOND
The handle bars will need fitting into the headstock. Remove the protective rub-
ber boot from the end of the handlebar assembly and slide into the headstock.
Adjust so that the handlebars are correctly aligned to the front forks and tighten
with a large Hex key. Take care to ensure that the cable assemblies are the cor-
rect side of the handlebars and the handlebar assembly rotates freely.
Remove the plastic packing piece in the bottom of the front forks and offer up
the front wheel into the two locating slots. Take care to ensure that the disc for
the front brake locates between the 2 front disc pads. It will be easier if the
wheel nuts are loosened slightly to ease assembly. Ensure that the two shaped
locking washers are aligned into the slots with the tabs at the bottom and tighten
the wheel nuts. Take care that the inner nuts are not adjusted.
Remove the front light clamp with a 10 mm spanner and refit together with the
front mudguard. Remove the 2 screws which will hold the mudguard stays and
refit through the loops in the stays using a Philips screwdriver.
The pedals, seat, inflation of the tyres and fitting of the rear light batteries follow
the same procedure as per the ONYX model described above.
(16 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern